Day 5:
First, place all the snap bushings in the ribs. Then, run the aluminum tubing from the outboard side through the fuel tank to the inboard side. Next, put on the B-nut and sleeve and flare the end of the tubing. (Made a video of this and hope to share it soon.) Cleco the inboard rib in place.
Connect the B-nut to the elbow fitting.
Install the access cover with the fuel pick-up tube.
Cut the vent line to length using a tubing cutter.
The tube gets sealed into the T-714 clip.
The vent line is installed.
You must be logged in to post a comment.